7
CPSMC0800-100 PointSystem
™
Chassis
slide-in-modules
2.1.2 Installing the Media Converter Slide-in-Modules
CAUTION: Wear a grounding device and observe electrostatic discharge precau-
tions when installing the Media Converter Slide-in-Module(s) into the chassis.
Failure to observe this caution could result in damage to, and subsequent failure
of, the Media Converter Slide-in-Module(s).
NOTE: Media Converter Slide-in-Modules can be installed in any installation slot,
in any order.
To install the Media Converter Slide-in-Module into the CPSMC0800-100 8-Slot
chassis:
1. Remove the Media Converter Slide-in-Module protective plate from the instal-
lation slot by removing the one (1) screw that secures the plate to the front of
the chassis.
NOTE: If the Slide-in-Module requires two slots, remove the protective plates
from two (2) adjacent installation slots.
2. Align the Media Converter Slide-in-Module with the chassis installation slot so
that the panel fastener screw is at the left of the Media Converter Slide-in-
Module.
3. Carefully slide the Media Converter Slide-in-Module into the installation slot.
NOTE: Ensure that the Media Converter Slide-in-Module is firmly seated against
the back of the chassis.
4. Install the Media Converter Slide-in-Module by carefully rotating the attached
panel fastener screw clockwise to secure the Media Converter Slide-in-Module
to the chassis.
5. Repeat steps 1 through 4 for additional Media Converter Slide-in-Module(s).
Tech Support: 7am-6pm CST (GMT -6:00) 1-800-260-1312 International: 00-1-952-941-7600
1.6A max. (60W max)
Komentáře k této Příručce